Parkside PHP 500 C2 Manual de usuario descargar pdf (Pagina 7)

4

PHP 500 C2

GB

Operation

Before ﬁ rst use

Preparing the glue site:

■ Do not use inﬂ ammable solvents to clean the

glue site.

■ The ambient temperature and temperature of

the materials to be glued must be not less than

+ 5° C and not warmer than + 50° C.

■ The glue sites must be clean, dry and free of

grease.

♦ Smooth surfaces should be roughened before

gluing.

♦ Warm any materials that are prone to cool

down quickly (e.g. steel) to improve the bond

with the glue.

♦ Screw on the appropriate nozzle .

Preparing the tool for use

Working with the mains lead connected:

♦ Connect the mains lead to the glue gun con-

nection (see Fig. B).

Insert the mains plug into the mains socket.

♦ Fold forward the plastic stand .

Stand the device up.

♦ Push a glue stick into the feed channel .

♦ Let the device heat up for about 5 minutes.

The device is now ready for use.

Cordless working:

♦ Connect the mains lead to the charger con-

nection .

Insert the mains plug into the mains socket.

♦ Place the glue gun into the charger .

♦ Push a glue stick into the feed channel .

♦ Let the device heat up for about 5 minutes.

The device is now ready for use.

♦ Repeat the heating-up procedure if the feed

switch becomes stiﬀ or the outcoming glue

becomes viscous.

Gluing:

♦ Press the feed clamp to regulate the ﬂ ow of

glue as required for your work.

♦ Apply the glue in individual dots. Apply in zig-

zags on ﬂ exible materials such as fabrics.

♦ Immediately after applying the glue, press the

two materials together for about 30 seconds.

The glued joint can be loaded after about 5

minutes.

♦ When you take a break from work, set the glue

gun down on the plastic stand or in the

charger .

♦ Remove any glue residue with a sharp knife

after cooling. Glued joints can be loosened

again by applying heat.

Switching oﬀ the device:

♦ Pull the mains lead out of the mains socket.

Changing the nozzle:

■ Wear protective gloves.

♦ Heat up the device for about 5 minutes.

Change the nozzle when it is hot.

■ Danger of burns!

Touch the nozzle only by the heat shield .

The nozzle tip is hot!

NOTE

Hold item upright, tip up, to prevent glue from

ﬂ owing out.

Maintenance and Cleaning

The glue gun is maintenance-free.

WARNING! Pull the mains lead out of

the mains socket before you clean the

tool. Always keep the device clean and

dry.

■ Do not allow any liquids to enter the tool. Use

a soft cloth to clean the housing. Never use

petrol, solvents or cleaning agents that might

attack plastic.

IB_60269_PHP500C2_LB4.indb 4 23.06.14 16:15

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comentarios a estos manuales

Sin comentarios