Parkside PLP 100 A1 Manual de usuario descargar pdf (Pagina 12)

13 GB

Switching off:

j Release the ON / OFF switch

j Pause: At least 48 seconds

CAUTION! Never heat up the device if it is not ﬁtted with a sol-

dering tip.

j ATTENTION! Never use in continuous operation mode. The ﬂow

of electrical current controls the delivery of soldering heat. As soon

as the ON / OFF switch

is released, the delivery of soldering

heat drops. If the ON / OFF switch

is pressed again, the deliv-

ery of soldering heat rises. Pay particular attention to achieving an

even delivery of soldering heat to ensure the highest soldering quali-

ty. You can do this by not allowing the soldering tip

to become

excessively hot.

Note: The device has a soldering light

to illuminate the work-

ing area.

Replacing a soldering tip

CAUTION! DANGER OF BURNS! Allow the device to

cool down before replacing a soldering tip.

j Release the two union nuts

using the open spanner

j Pull the soldering tip

out of the holder.

j Insert another tip into the holder.

j Tighten the two union nuts

using the open spanner

Use

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 101 102

Sin comentarios

Parkside PLP 100 A1 Manual de usuario Pagina 12